News Center
11-18
Application of sliding bearing
With the rapid development of the process industry in China, more and more large-scale chemical projects, such as million tons of ethylene, million tons of oil refining, gigawatt thermal power, and the West to East Gas Transmission, have been implemented.
11-18
What causes oil leakage of HV motor bearing bush (sliding bearing)?
1. Structural and processing reasons ① Imperfect shaft seal structure ② Deformation of joint surface between pad base and pad cover ③ Poor shaft seal design
11-18
Analysis of the causes of bearing bush wear
(1) The alloy layer is cast with defects, micro cracks or hidden danger of shelling, rough surface, air holes inside, and natural wear is fast after being put into operation.
11-18
Most bearing damage can be caused by incorrect bearing installation
In fact, 80% of bearings fail early because they are not installed correctly. The correct installation of the bearing can not only increase the service life of the bearing, reduce the cost, but also greatly improve the production efficiency.
11-18
Repair method of bearing bush wear
(1) Check the wear of the bearing seat; (2) Oxygen and acetylene are used to degrease the pad seat, and angle grinder is used to polish the repair surface to remove high spots;
11-18
Typical structure of plain bearings
1、 Structure of radial sliding bearing 1. Integral sliding bearing The structure is simple, the cost is low, the assembly and disassembly are inconvenient, and the clearance between the shaft diameter and the bearing cannot be adjusted. It is used in light load, low speed and intermittent working occasions.
11-18
What are the differences between bearings and bearing shells
1. The definitions of bearings and bearing shells are different Bearing is an important part of modern mechanical equipment. Its main function is to support the mechanical rotator, reduce its friction coefficient in the movement process and ensure its rotation accuracy.
11-18
High quality performance of bearing bush products shall be guaranteed in this way
Bearing shells are used in many mechanical equipment today. The appearance of this product has effectively extended the service life of the equipment and improved the production and processing efficiency of the factory, so it has become the focus of many factories. Therefore, many users pay more attention to it. What can we do to make the bearing bush products have good performance all the time? Here is a brief introduction.